Ultraloc logoselect - Ultralocselect - Technologyselect - Productsselect - Businessselect - Contact
Precision Power
   

Hints & Tips
Ensure that the surfaces to be bonded are close fitting and clean.
For smooth non porous surfaces use ULTRALOC Liquid. Use sparingly for best results.
For abrasive porous surfaces use ULTRALOC Gel. Use just enough glue to allow for flow into gaps when pressed together.
For vertical or other difficult angled surfaces use ULTRALOC gel.
Slightly dampen porous surfaces such as China, Wood.
Pointing the tube away from the face, apply a small amount of ULTRALOC to one surface only.
Squeeze the base of the tube gently and apply sparingly.
Use on a suitable work surface. Always cover easily damaged surfaces.
   
Avoiding skin contact with ULTRALOC, press parts together for about 10 seconds.
Wipe the nozzle thoroughly with a dry tissue, replace cap and return tube to original pack, retain for all instructions.
Store tube in cool dry place, out of reach of children. (Useful life approximately 12 months once opened. This may vary due to storage conditions).
In general a little goes a long way. One average sized drop from our tube will cover 2cm2. The thinner the bond line the better the overall performance!
Oops!!
ULTRALOC can be removed with acetone (nail varnish remover) please take care to note the surface does not get damaged by such chemicals.
Body heat and moisture from skin cause instant setting, so be careful when using ULTRALOC.
Although Cyanoacrylate reacts instantly with water making it virtually impossible to swallow, seek immediate medical attention if swallowed.
In case of bonded skin, soak in warm soapy water and peel apart with blunt object.
select - Test reportselect - Precaution
Ultraloc®, Precision Power™ are registered trade marks. © 2008 Multibrands